2021-04-15
No. | Symptom | Cause Analysis | Remedy |
1 | Air leak | Temperature is too low, | raised sealing temperature (Each plastic film at different temperatures) |
Whether the top to the heating block silicone | Check whether the heating block slider stuck | ||
Whether heating heating block | Check heating element (temperature controller, solid state relays, heating pipes) | ||
2 | Sealing wrinkling | Zigzag incision film | Blade passivation, resistance, replace the blade |
With the outer surface of the melting temperature of the film | junk film removed or replaced with a high | ||
3 | High temperature with a deviation | High temperature zone too loose | Adjusting the rear seat springs |
Front and rear wheels are not parallel to | adjust front seat bottom screws (see 5.1) | ||
Front and rear slide down from the high temperature zone (2-3 times) | high-temperature zone is damaged, replace with a new high-temperature | ||
Excessive resistance membrane drum sets | Debug or overhaul film roll | ||
4 | Continuous process of film rupture inflatable | Gas nozzle surface is not smooth | Replacing the smooth appearance of the gas nozzle |
Film inflatable mouth with gas nozzle is not in a straight line | to adjust the position limit set |